|
Post by mwardncsu on Jul 8, 2013 14:54:18 GMT -5
Selling for $25, used to have HDS-10 mounted to it - this is the larger, pivoting mount. Will ship via USPS or other for cost, from ZIP 27302, or meet you at/on the lake.
|
|
|
Post by jon on Jul 8, 2013 20:57:55 GMT -5
How wide is the mount? I am wondering if its too wide for a hds7
|
|
|
Post by mwardncsu on Jul 8, 2013 21:04:29 GMT -5
Jon - unfortunately I can't put my hands back on it to check until the 19th or 20th and I did not think to put a tape measure in the pic I took a little while ago - but I can let you know the specific measurements then - Iooked today on the JohnnyRay website to try and figure out the specific model and get dimensions but was not exactly sure....
The website does show using the same model for an HDS-10 and HDS-7 - says JR-207, which from the pic looks like a narrower base than mine - there is a wider JR-209 model but it does not have the extra set of mounting holes that mine does - I expect mine used the inner holes in the Lowrance gimbal mount and the rest was supporting it - I guess you could always trim the width to fit.....
|
|
|
Post by archenemy on Jul 10, 2013 7:39:48 GMT -5
It is 3 1/8 by 6 1/8. Rock solid mount have an hds8 attached to mine.
Sent from my DROID RAZR using proboards
|
|
|
Post by mwardncsu on Jul 21, 2013 12:30:41 GMT -5
Just checked measurements - this one is 10"x3.25" and there are two sets of holes
9"x2.25" and then a second set drilled at 5.5"x (something narrower). The Lowrance gimbal mount was attached to this second drilled set.
|
|
|
Post by mwardncsu on Feb 19, 2014 21:43:54 GMT -5
this is still available if anyone is rigging out a new ride....
|
|